Thermador T24UR820DS Guide D'installation page 16

1. Install the custom handle of your preference on the overlay panel before installing the panel on
the drawer.
* Every custom handle is different and it is the responsibility of the customer to make the
necessary adjustments to place the handle on the overlay panel.
The screws used to affix the custom handle to the panel must be flat and flush with the surface of
the panel; if the screws are not flat, then consider making a recession on the overlay, enough to
hide the head of the screw below the surface of the overlay, otherwise the screws will interfere
with the correct placement of the overlay on the drawer.
Install custom
handle first.
2. Fix the hooks provided in the "Installation Kit" into the four rectangular recessions; use the screws
included in the same "Installation Kit". The hooks must be on the outer edge of the panel and
pointing down.
*
Overlay Frame with
Door
custom handle
Flat screw flush with surface
Overlay Frame with
Door
custom handle
Round head screw hidden in a
recession on the overlay.
Page | 16