Esoteric D-07X Mode D'emploi page 17

Analog output setting
Display: OUT>***
Regardless of the input setting, audio will not be output from the
o
LINE OUT jacks if headphones are connected to the PHONES jack.
RCA
Analog audio signals are output through the RCA jacks.
XLR2
Analog audio signals are output through the XLR connectors with
pin 2 HOT.
XLR3
Analog audio signals are output through the XLR connectors with
pin 3 HOT.
XLR output gain setting
Display: XLR>***
This setting only appears when the analog output is set to XLR2 or
o
XLR3.
Depending on the connected amplifier, either the "+6dB" setting
o
or the "0dB" setting might result in the same volume as the RCA
jack input.
+6dB
Set the XLR output level to double the RCA output level (+6 dB).
If the sound clips when set to "+6dB", change the setting to "0dB".
o
0dB
Set the XLR output level to the same level as the RCA output level
(0 dB).
USB input setting
Display: USB>***
This item only appears when in the input source is set to USB.
o
When set to use a HIGH SPEED mode, dedicated driver software
o
must be installed on the computer. Download the driver software
from our website (see page 19).
NORM
Connect using USB FULL SPEED mode.
The sampling frequencies that can be input are 32 kHz, 44.1 kHz,
48 kHz, 88.2 kHz and 96 kHz.
HS_1
Connect using USB HIGH SPEED mode.
The sampling frequencies that can be input are 32 kHz, 44.1 kHz,
48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz and 192 kHz.
HS_2
Connect using USB HIGH SPEED asynchronous mode.
The sampling frequencies that can be input are 32 kHz, 44.1 kHz,
48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz and 192 kHz.
In asynchronous mode, the clock signal of this unit is used for play-
back of the audio data transmitted from the computer.
If skipping noise occurs during playback when set to HS_2, set
o
the unit to HS_1 instead.
17