Haier WS53GDA Manuel D'utilisation page 20

10- Troubleshooting
10.2 Troubleshooting without display code
Problem
The compressor
does not work.
The appliance runs
frequently or runs
for a too long pe-
riod of time.
The inside of the
wine cellar is dirty
and/or smells.
It is not cold enough
inside the appli-
ance.
It is too cold in-
side the appli-
ance.
Moisture forma-
tion on the inside
of the wine cellar
compartment.
20
Possible Cause
• Mains plug is not connected to the
mains socket.
• The indoor or outdoor tempera-
ture is too high.
• The appliance has been off power
for a period of time.
• A door of the appliance is not tight-
ly closed.
• The door has been opened too
frequently or for too long.
• The door gaskets are dirty, worn,
cracked or mismatched.
• The required air circulation is not
guaranteed.
• The temperature is set too low.
• The inside of the wine cellar needs
cleaning.
• The temperature is set too high.
• Bottles have been added recently.
• A door of the appliance is not tight-
ly closed.
• The door has been opened too
frequently or for too long.
• The door gaskets are dirty, worn,
cracked or mismatched.
• The temperature is set too low.
• The climate is too warm and too
damp.
• A door of the appliance is not tight-
ly closed.
• The door has been opened too
frequently or for too long.
Possible Solution
• Connect the mains plug.
• In this case, it is normal for the ap-
pliance to run longer.
• Normally, it takes a while for the
appliance to cool down com-
pletely.
• Close the door and ensure the
appliance is located on a level
ground and there is no food or
container jarring the door.
• Do not open the door too fre-
quently.
• Clean the door gasket or replace
them by the customer service.
• Ensure adequate ventilation.
• The problem will resolved itself
when the desired temperature
has been reached.
• Clean the inside of the wine cellar.
• Reset the temperature.
• Allow time for recently added
bottles to reach desired temper-
ature.
• Close the door.
• Do not open the door too fre-
quently.
• Clean the door gasket or replace
them by the customer service.
• Reset the temperature.
• Increase the temperature.
• Close the door.
• Do not open the door too fre-
quently.
GB