Aqua Medic spectrus Mode D'emploi page 17

3. Enter the name and password for the WLAN router (household WLAN).
4. Press "Connect" to connect the lamp to the desired wireless router.
5. When the lamp emits a beep, it means successful communication.
6. If the connection is successful, the indicator lamp remains lit. If the connection fails, the red LED on the back
of the light will flash.
7. Make sure that the red LED is still lit, return to the settings page for the mobile phone and connect the mobile
phone to the desired WLAN router (household WLAN).
8. Open the AMled App settings page and first delete the name of the lamp you want to connect to. Press "Search
Light" to find the lamp. Remove the ticks behind all the lights displayed; just put one behind the name of the
lamp you want to connect to.
9. Then tap on the name of the lamp to connect.
Always connect to one light only, not to several at the same time.
Reminder:
If the SSID (AMled-xxxxx) can't be found on your mobile phone after turning on the Aqua Medic LEDs, please
press the "Factory Reset Key" three seconds on the back of the light for factory settings. Before joining the router,
be sure each of the light has been successfully completed the "connect to light directly" mode. Then go to App
setting page to join the router.
7. Controlling and Program
)
1. Connect
Tap to access the connect page.
17