Operating Safety Instructions; Preparation For Work - LUND 79363 Manuel D'instructions

aforementioned instructions. Use the tool in accordance with
its purpose, taking into account the kind and conditions of
work. Should the tool be used for other applications than the ones it
has been designed for, the risk of a dangerous situation increases.
Repairs
The tool may be repaired only by authorised service centres,
which must use solely original spare parts. It will guarantee a
proper level of safety of operation of the electric tool.
FITTING ACCESORIES
NOTE! Fitting of accessories must be executed exclusively with
the power supply off (Remove the plug of the cord of the tool from
the socket!)
The soldering tool is supplied complete and does not require as-
sembly.

OPERATING SAFETY INSTRUCTIONS

It is prohibited to use the soldering tool with a tapered soldering tip.
It is prohibited to touch the insulation of electrical cables with a
hot soldering tip.
It is prohibited to use the soldering tool in high humidity conditions
and in an atmosphere of explosive and caustic gases and dust.Do
not repair damaged electrical conductors of the tool.
In case the electrical cord of the tool is damaged, it must be
replaced with a new one.
Replacement of a damaged electrical cord of the tool must be
performed by a qualifi ed electrician.
Do not solder live elements!
12
O P E R A T
GB
After work place the tool on its stand and wait until the soldering
tool has cooled down. This is the only acceptable manner of cool-
ing the tool. Do not cool the soldering tool submerging it in water,
since it may lead to an electric shock.

PREPARATION FOR WORK

Before work check whether the body and the cord with a plug and
the external extension cords are not damaged. If necessary clan
the tool and the ventilating holes. If any damage is detected, it is
prohibited to continue working!
Note! All activities related to replacement of the soldering tip, light
bulb, etc. must be performed with the power supply of the tool off ,
so before you proceed to execute them: Remove the plug of the
cord of the tool from the socket!
Before using the tool, make sure the parameters of the mains com-
ply with those indicated in the rating plate.
Before soldering clean thoroughly the metal elements to be sol-
dered, as well as the soldering tip of the tool. In case the soldering
tip is burned, it must be replaced with a new one.
USING THE TOOL
Soldering should be performed by an adult who is acquainted with
the safety regulations for soldering.
Note! The tool has not been designed for continuous operation!
The maximum time of operation is 12 seconds, after which work
must be interrupted for at least 48 seconds.
I N G M A N U A L