LUND 79363 Manuel D'instructions page 11

Do not expose electric tools to precipitation or humidity. Water
and humidity which gets into the electric tool increases the risk of
an electric shock.
Do not overload the power supply cable. Do not use the power
supply cable in order to carry the tool or to connect and dis-
connect the plug from the mains socket. Avoid contact of the
power supply cable with heat, oils, sharp tools and moving
elements. Damage to the power supply cable increases the risk
of an electric shock.
In case work is realised outside closed areas, it is necessary
to use extension cords designed for applications outside
closed areas. Using a correct extension cord permits to reduce
the risk of an electric shock.
Personal safety
Commence work in good physical and psychological condi-
tions. Pay attention to what you do. Do not work if you are
tired or under eff ects of medicines or alcohol. Even a moment's
inattention during work may lead to serious injuries.
Always use individual means of protection. Always wear gog-
gles. Using individual means of protection, such as dust-masks,
protective shoes, helmets and hearing protections permits to re-
duce the risk of serious injuries.
Avoid accidental activation of the tool. Make sure the switch is
in the OFF position, before you connect the tool to the mains.
Holding the tool with a fi nger on the switch or connecting an elec-
tric tool when the switch is in the ON position may lead to serious
injuries.
Before you turn an electric tool on remove all the spanners
and other tools, which have been used for adjustments. A
spanner left on rotating elements of the tool may lead to serious
injuries.
O P E R A T
GB
Keep your balance. Maintain an appropriate position. It will
permit to control the electric tool in case of unpredicted situations
during its operation. Use protective clothes. Do not wear loose
clothes or jewellery. Keep your hair, clothes and gloves away
from moving elements of the electric tool. Loose clothes, jew-
ellery or long hair may get caught on moving elements of the tool.
Use dust extractors or dust containers, if the tool is equipped
with any. Make sure they are properly connected. Using of dust
extractors permits to reduce the risk of serious injuries.
Operation of the electric tool
Do not overload the electric tool. Use a proper tool for the
given purpose. A correct selection of the tool for the given work
will result in a more effi cient and safer work.
Do not use the electric tool if the switch is not functioning
properly. A tool which may not be controlled by means of a switch
is dangerous and must be repaired.
Disconnect the plug from the mains socket before any adjust-
ment, replacement of accessories or storage of the tool. It will
permit to avoid accidental activation of the electric tool.
Store the tool away from children. Do not allow untrained per-
sons to operate the tool. An electric tool may be dangerous in
hands of an untrained person.
Make sure the tool is properly maintained. Check the tool
in order to detects any unfi tting or loose moving elements.
Check whether the elements of the tool are not damaged. In
case any damaged elements of the tool are detected, they
must be repaired before the electric tool is operated. Many
accidents are caused by improper maintenance of tools.
Cutting tools must be sharp and clean. Properly maintained
cutting tools are easier to control during work.
Use electric tools and accessories in accordance with the
I N G M A N U A L
11