Technical Data - LUND 79363 Manuel D'instructions

PROPERTIES OF THE TOOL
The soldering tool has been designed for the purpose of solder-
ing metals with tin and lead binders for soft soldering. A correct,
reliable and safe functioning of the tool depends upon appropriate
operation, and therefore:
Before work with the tool, read the complete instruction and
keep it.
The supplier will not be held responsible for any damage and inju-
ries which occur as a result of inappropriate applications of the tool,
failure to observe safety regulations and the recommendations
specifi ed in these instructions. Improper application of the tool will
also cause cancellation of any guarantee rights due to incompli-
ance with the sales contract.
EQUIPMENT
The soldering tool is provided complete and has additional acces-
sories: spare soldering tips, rosin and soldering tin.

TECHNICAL DATA

Parameter
Catalogue number
Rating voltage
Rating frequency
Paring power
Work mode
10
Unit of measurment Value
79363
[V] ~230
[Hz]
[W]
S2 20% 12 s / 48 s
O P E R A T
GB
Parameter
Dimensions (length x width x height)
Weight
Electric insulation class
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to ob-
serve them may lead to an electric shock, fi re or injuries. The notion
of electric tool used in the instructions applies to all the tools which
are powered with electric current, both wire tools and wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Dis-
order and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or
those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of
contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A
lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket.
Do not modify the plug. Do not use any adapters whatsoever
in order to adapt the plug to the socket. Unmodifi ed plug which
fi ts the socket reduces the risk of an electric shock.
50
Avoid contact with grounded surfaces, such as pipes, heaters
100
and refrigerators. Grounding of the body increases the risk of an
electric shock.
I N G M
Unit of measurment
[mm]
[kg]
A N U A L
Value
170 x 50 x 160
0,6
II