Muskoka MADIGAN MTVS2353SMG-1 Mode D'emploi page 5

6. Locate side panels F & G. Insert 6 wood dowels into the edge of
each panel.
7. Line up and insert cam lock dowels and wood dowels on panels
F and K and push together until flush. Insert 2 cam locks into the
holes on panel F. Make sure the arrows on the cam locks are facing
toward panel K. Turn the cam locks to tighten. Do not strip the cam
locks by over tightening.
Repeat process for panels G and L.
8. Line up the wood dowels in panel D with the holes in panel H
and the cam lock dowel in panel H with the holes in panel D.
Push together until flush. Insert a cam lock into the center hole at
the bottom of panel D. Make sure the arrows on the cam lock are
facing toward panel H. Turn the cam lock to tighten. Do not strip
the cam lock by over tightening.
Repeat the process for panels E and I.
F
G
Hardware Used
c wood Dowel
F
K
Hardware Used
a Cam Lock
D
H
Hardware Used
a Cam Lock
x 12
G
L
x 4
E
I
x 2
5