Pressure Relief Procedure; Priming; Preparing To Prime - Titan ProFinish AS1130 Notice D'utilisation

Pressure Relief Procedure

Follow this procedure after the unit is assembled and before
any operation which involves the spray gun such as cleaning
and maintenance or changing tips or accessories.
1. Turn the pressure control knob counterclockwise to its
lowest setting.
Pressure Control Knob
PRIME/SPRAY Knob
2. Turn the PRIME/SPRAY knob to PRIME.
3. Trigger the gun to remove any pressure which may still be
in the hose.
4. Lock the gun by turning the gun trigger lock so that it is
parallel to the gun body.
Gun locked OFF
(gun will not spray)
WARNING
Injection hazard. Do not spray without the tip guard in place.
NEVER trigger the gun unless the tip is completely turned to
either the spray or the unclog position. ALWAYS engage the gun
trigger lock before removing, replacing or cleaning tip.
English

Priming

Preparing to Prime

1. Fill the inlet valve with water or with a light household oil.
2. Make certain that the PRIME/SPRAY knob is set to
PRIME and that the pressure control knob is turned
counterclockwise to the lowest pressure setting.
3. Turn the motor switch to ON.
4. Increase the pressure by turning the pressure control
knob clockwise 1/2 turn.
5. Force the inlet valve to open and close by pushing on it
with a screwdriver or the eraser end of a pencil. It should
move up and down about 1/16 of an inch. Continue until
water or oil is sucked into the sprayer. This will wet the
moving parts and break loose any old paint residue.
6. Put the palm of your hand over the inlet. Turn the
pressure control knob clockwise to its maximum setting.
You should feel suction coming from the inlet valve. If you
do not, see the section on cleaning and servicing the outlet
valve.
7. Turn the pressure control knob counterclockwise to the
minimum pressure setting.
8. Turn the motor switch to OFF.
6 © Titan Tool Inc. All rights reserved.