Let's Get Started; Window Slider Kit Installation - TCL W8P95-B3 Mode D'emploi

Let's Get Started!

Installation & Assembly Instructions
Step 1: Assemble and Attach the Exhaust Hose
• Extend both sides of the hose. (Fig. 1a)
• Screw on the hose inlet (Fig. 1b)
• Screw on the hose outlet (Fig. 1c)
• Attach the exhaust hose by sliding the hose inlet from the top down into the air
outlet grille. (Fig. 1d)
1a.
Step 2:

Window Slider Kit Installation

Parts Needed:
A. Panel (x2)
B.
Panel with one hole
C.
Screw or plastic pin
Assembly
1. Slide Panel A into Panel B and size to window width (use second Panel A if necessary).
Windows sizes vary. When sizing the window width, be sure that the window kit assembly is
free from gaps when taking measurements. If necessary, cut Panel B
down to size. Cut on the side opposite the hole.
2. Lock the screw into the holes that correspond with the width that your
window requires to ensure that there are no gaps in the window kit
assembly after installation.
3.
Use the provided foam seal to fill in any gaps.
Window slider
4.
Attach the hose outlet to the window slider kit.
1b.
A
1a.
Window slider
8
Vertical
1c.
C
A
C
1a.
A
B
1b. 1c.
Vertical
window
1d.
Slide onto
B
C
A
B
1b.
1d.
Horizontal
window
C
A
1c.