Bosch GSR18V-1330C Consignes De Fonctionnement/Sécurité page 17

2610056705 GSB18V-1330C 04-21.qxp_GSB18V-1330C GSR18V-1330C 5/3/21 7:00 AM Page 17
User Interface
STATUS INDICATOR LED
The LED bar at the top of the user interface
illuminates in various colors to help the
user identify the status of the tool. When
the status indicator LED (20) is green the
tool and battery pack are operating
normally and temperatures are ok. If the
indicator changes to yellow it means that
the tool or battery temperatures have risen
to a critical level. It is best to back off the
load and give the tool a chance to cool
down. If the indicator turns red the tool
will shut off to protect itself and/or the
battery pack from an overheating situation.
The status indicator LED (20) will also blink
blue when the leveling function (18) or
KickBack Control (22) buttons are held for
7 seconds. This will reset the tool settings
to factory default.
KICKBACK CONTROL (RAPID SHUT-OFF)
To ensure better control of the tool
during operation, this tool is design
to shut-off while in use if a sudden
or unexpected bind up situation
occurs. Bind up occurs when the bit gets
jammed during operation, which forces the
bit to stop spinning abruptly. If this occurs,
the tool will shut down and the KickBack
Control will be indicated by flashing LED
lights on the tool.
KickBack Control can be turned off by the
user. Button (22) on the user interface (14)
will toggle the feature on and off. Status is
indicated with "On" and "Off" LEDS (21) on
the User Interface (14). If the power tool is
not used for longer than 5 minutes, or if
the battery is removed, KickBack Control
automatically turns back on.
Please note that the indicator light may not
be visible from all directions or in bright
sunlight.
When the switch trigger is pressed,
operator is notified about the KickBack
Control.
LEVELING FUNCTION
With the leveling function, a slope angle
can be preselected for power tool
detection and indication during work. This
means it is possible to drill or screw
Operating Instructions
FIG. 15
(20)
(19)
(18)
perpendicular to sloped surfaces, for
example. The leveling function is con-
trolled via the user interface (14).
Select an angle (45°, 60°, user-defined) on
the user interface (14). Note: The default
user-defined angle is 90°. This angle can be
adjusted via the Bosch Toolbox app using
connectivity
separately). To adjust the angle, press the
button for the leveling function (18)
repeatedly until the LED of the required
slope angle (19) starts flashing.
In addition to the LED of the required slope
angle (19), the LED of the leveling
function (8) also starts to flash yellow. Now
position the power tool on the reference
surface and hold it as still as possible.
Note: If the power tool is not held still
during the initiating process, the initiating
process will automatically end after
10 seconds and the last set value is
restored.
The power tool will start the initiating
process once it is positioned. The
reference surface is set as o° during the
initiating process. The initiating process is
complete when the LED of the leveling
function (8)
approximately 1 second and then goes out,
and the LED of the slope angle (19) lights
up continuously.
Remove the power tool from the surface.
Align the power tool with the reference
surface at the required slope angle. The
LED (20) lights up yellow if the tool angle
lies in the range +/-10° from the preset
slope angle.
17
(21)
(22)
(23)
module GCY42 (sold
lights up green for