Arregui CI10-AL Mode D'emploi page 15

CI10-AL
SURFACE ASSEMBLY INSTRUCTIONS
H
1. Calculate the position where you want to
install the lock, always inside the door. Place
the adhesive spacer (H) as shown in the image,
stuck to the body of the lock.
M
B
4. Once the base plate (B) and the shims (C), if
necessary, have been pre-positioned, drill and fix
to the door using the screws provided (M).
E
I
6.B Position the bolt storage part (E) on the door
frame, fixing it with an adhesive strip (I) at the
correct height to ensure the lock can be closed
and the door locked.
E
1
8. Press the trim (E1) into place.
E
2.Next to the adhesive spacer (H), position the
bolt storage part (E) on the door frame. The
spacer marks the minimum distance between
the lock and the bolt storage part. If both these
parts are not at the same height, you must use
the shims (C) to wedge the lock as shown in
step 4.
B
L
5. Screw the body of the lock (A) to the base
plate (B) using the four screws provided (L).
E
M
7.A Repeat the drilling process to fix the bolt
storage part (E) to the door using the screws
provided (M).
I
B
3. Fix the adhesive strips (I) to the rear of the
base plate (B) or the shims (C) to suitably
position it on the door before drilling.
A
A
6.A To ensure the bolts are well-adjusted, part E
may be installed in two different positions. With the
bolts in the closed position, check where it is to be
installed. The bolts must remain as close as possible
to the edge of part E to prevent slackness when
opening the door.
7.B Check the magnet (D) is positioned oppo-
site the bolts.
Important: Check the lock
functions correctly, always from
inside the home.
En

E
D
15