Safety guidelines
•
Only use the device for its intended purpose.
•
The device must only be connected to a supply voltage corresponding to the electrical
rating shown on the unit.
•
The device should be connected to a socket outlet near the equipment that is easily
accessible.
•
Do not connect multiple adaptors or use an extension cable.
•
Failure to follow these instructions could result in damages/injuries and will invalidate
your guarantee.
•
Do not attempt to service or repair the device yourself.
•
If recycling, separate paper and credit card shreds.
•
Do not use this device if the cable or plug have been damaged.
•
Care should be taken when moving equipment to avoid any uneven surfaces.
•
Please read all the safety information and the instructions. The manufacturer is not liable
for cases of material damage or personal injury caused by incorrect handling or non
compliance with the safety instructions. In such cases, the warranty will be voided.
•
The device is intended for use indoors. Never use it outdoors.
•
Keep the device away from moisture.
•
Be vigilant at all times, and always be careful what you are doing. Do not use electrical
equipment if you are lacking in concentration or awareness, or are under the influence of
drugs, alcohol or medication. Even a moment of inattentiveness can lead to serious injuries
when using electrical equipment.
•
Do not attempt to open, modify or repair the device. Do not drop, puncture, break or
expose it to high pressure.
•
Alterations to the device and technical modifications are not permitted.
•
Check the device and cable (and if applicable, the adapter) for any damage before use. If
there is any visible damage, a strong odour, or excessive overheating of components,
unplug all the components immediately and stop using the device.
•
Shredder must be disconnected from power source, if not used for an extended period of
time.
•
Do not use spray cleaners or spray lubricants as these may present a risk of fire.
4. PRESCRIBED USE
Only use the APS46K shredder to shred paper and credit cards! For the paper to be shredded, it
-
must be dry and comply with the requirements presented in Chapter "Technical Specifications"!
Attempting to shred other material can lead to personal injuries (e.g. through splinters from
hard material, etc.) and damage to the equipment (e.g. damage to the cutting mechanism etc.).
Remove all paper clips and staples from paper before introducing it in the device!
-
Do not shred continuous forms in this device!
-
The device may only be used in dry, indoor rooms.
-
4 |
Page