Extension Cord; Double Insulation - Black & Decker NHT518 Mode D'emploi

WARNING:
do not expose to rain, do not use on wet surfaces. Store indoors.
SAVE THESE INSTRUCTIONS
WARNING
:
contains chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm. Some examples of these
chemicals are:
• compounds in fertilizers
• compounds in insecticides, herbicides and pesticides
• arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety
equipment such as dust masks that are specially designed to filter out
microscopic particles.
The label on your tool may include the following symbols.
V................volts
Hz..............hertz
min ............minutes
..........direct current
.............. Class II Construction
............safety alert symbol
To reduce the risk of electrical shock;
Some dust created by this product
A ....................amperes
W ..................watts
..................alternating current
n o ..................no load speed
..................earthing terminal
.../min ............revolutions
per minute
Make sure your extension cord is in good condition. When using an

Extension Cord

extension cord be sure it is heavy enough to carry the current your
product will draw. An undersized extension cord will cause a drop in
line voltage resulting in loss of power and overheating. The following
table shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the cord.
Minimum Gage for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V 0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More Not more
Than Than
0 - 6 18
6 - 10 18
10 - 12 16
12 - 16 14
Double insulated tools are constructed throughout with two

Double Insulation

separate layers of electrical insulation or one double thickness
of insulation between you and the toolʼs electrical system.
Tools built with this insulation system are not intended to be
grounded. As a result, your tool is equipped with a two prong
plug which permits you to use extension cords without concern
for maintaining a ground connection. NOTE: Double insulation does
not take the place of normal safety precautions when operating this
tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.
REPLACEMENT PARTS: When servicing all tools, USE IDENTICAL
REPLACEMENT PARTS. Repair or replace damaged cords.
4
26-50 51-100 101-150
51-100 101-200 201-300
American Wire Gage
16 16 14
16 14 12
16 14 12
12 Not Recommended