Installation - Kozy Heat Fireplaces KOMFORT ZONE KIT Manuel D'installation

4.0 INSTALLATION

The Kozy Zone Kit requires that the convection baffle, located above
the firebox inside the appliance metal cabinet, to be removed to
allow the hot airflow to convect upwards into the air ducts installed
on the fireplace.
1. Remove the convection baffle from the appliance.
CLW-72: The baffle is secured by (2) screws right behind the
upper edge of the fireplace opening.
BHM-52: The baffle is secured by a baffle clip with (2) screws
in the front center, and (2) screws right behind the upper edge
of the fireplace opening. Recycle this panel as it is no longer
needed.
Recycle this panel as it is no longer needed.
TAKE-OFF COLLAR
CONVECTION BAFFLE
TO BE REMOVED
CONVECTIVE AIRFLOW WITH
THE BAFFLE IN PLACE
Figure 4.1, CLW-72 Air Flow with Convection Baffle Removed
Figure 4.2, CLW-72 Convection Baffle Removal
Baffle Clip
Figure 4.4, BHM-52 Convection Baffle Removal
Komfort Zone Kit #KZK-1510 R.5
CONVECTION AIRFLOW
WITH BAFFLE REMOVED
FIREBOX
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
Figure 4.3, CLW-72 Cover Plate Removal
Figure 4.5, BHM-52 Cover Plate Removal
2. CLW-72: Remove (6) cover plates on top of the appliance (4
screws each).
BHM-52: Remove (2) cover plates on top of the appliance (4
screws total).
3. Align the take off collars to the corresponding holes on top of
the appliance. Secure with screws previously removed. Install
the take off collars to the corresponding opening(s) on the
plenum(s). Use supplied screws.
4. Frame a rough opening at the desired location. See previous
pages of this manual for allowable plenum positions and rough
frame opening sizes.
Instructions continue on the next page.
21