3.2.3 BHM-52 Combustible Wall Finish
•
Figure 3.6 shows installation of combustible wall finish up to 1"
thick. This combustible material goes on any required non-
combustible materials as shown in Figure 3.3 on page 15.
•
This 1" (25mm) combustible material is able to go down to the
fireplace finishing edge.
•
See Figure 3.4 on page 16 for up to 1" (25mm) thick
combustible material installation around the KZK air discharge
grille.
Non-combustible zone
Combustible wall nish
up to 1" (25mm) thick
may be installed up to
the top nishing edge
Non-combustible
material only
Figure 3.7, KZK-1510 Combustible Wall Finish for BHM-52
18
BHM-52
Top nishing
edge
Bottom
nishing
edge
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
Komfort Zone Kit #KZK-1510 R.5