Sauder Credenza 415979 Instructions De Montage page 19

Step 15
Carefully turn your unit over onto its front edges. Hold the
å
bottom HINGES up so they do not hit the fl oor.
Unfold the BACK (G) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (G). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (G) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
UPRIGHTS (C and D).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
Perforations should be
located near this edge.
www.sauder.com/service
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(44 used in this step)
These holes must line up over
the UPRIGHTS (C and D).
G
415979
1N
NAIL
Page 19