Quick Start Guide - GBC PUNCH G2 Manuel D'instructions Et D'utilisation

3. QUICK START GUIDE

PUNCH G2 must be connected to AC power to enable any feature
of the machine. Below are three modes of operation of PUNCH G2.
1. Bypass Mode:
This operation will allow paper to pass through the PUNCH G2
without being punched.
This is the default mode of operation for PUNCH G2. Make sure
the Punch Icon is not selected in the printer's User Interface.
2. Single Punch Mode:
This operation will punch the trail edge of all sheets that pass
through the PUNCH G2.
Step 1: A properly configured die set must be inserted before
running punch mode. See section 4.A for details on Die set
changes and follow the labels on the die set for configuration.
Step 2: Before starting a print job select the Punch mode from
the printer's UI.
PUNCH G2 will now function in Single Punch mode.
3. Double Punch Mode:
This operation will punch the two rows of holes- One in the middle
of the sheet and the other adjacent to the trail edge of all sheets
that pass through the PUNCH G2.
Step 1: A properly configured die set must be inserted before
running punch mode. See section 4.A for details on Die set
changes and follow the labels on the die set for configuration.
Step 2: Before starting a print job enable Double Punch from
the printer.
PUNCH G2 will now function in Double Punch mode.
DOWN
Layout of PUNCH G2 LCD User Interface
4. Die Set Configuration:
To configure the Die Set for the desired sheet size that is being
processed see section 8 – Die Set User Manual.
UP
ENTER
5. Restrictions:
I. Using clear cover other than 7 mil may cause a jam to occur
and could require a service call.
II. When punching 300gsm paper or above, with grain direction
in the long orientation, paper jams may occur. The problem
may not occur with the grain direction in the short
orientation.
PUNCH G2
EN
5