Troubleshooting And Maintenance; The Icons And Error Messages; Error Display - Omron MC-521-E Mode D'emploi

MC-521-E_A_M_main.book Page 12 Monday, April 16, 2018 5:11 PM

4. Troubleshooting and Maintenance

4.1

The Icons and Error Messages

In case of any of the below problems occur during measurement, first check that no other electrical device is
within 30cm. If the problem persists, please refer to the table below.

Error Display

Device stabilization in process.
Prove cover is not attached correctly.
Battery is low.
Measurement before device stabilization.
12
Cause
Wait until
Attach the probe cover again until
flashing.
Replace the battery.
(Refer to section 4.3)
Wait until
Remedy
stops flashing.
stops
stops flashing.