PARTS LIST:
1
Driver/left Sidebar
1
Passenger/right Sidebar
4
Sidebar Brackets (use for left or right)
12
8mm Plastic Washers
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING
INSTALLATION. ASSISTANCE IS RECOMMENDED.
1. Start the installation under the driver side of the vehicle. Locate the front and rear factory running board
mounting locations along the inner side of the body, (Figure 1).
2. Slide (1) Plastic Washer over each factory mounting stud in the body panel, (Figures 2 & 3). IMPORTANT: The
Plastic Washers are designed to prevent corrosion between the aluminum body panel and the steel mounting
brackets. Do not install the Brackets without the Plastic Washers.
3. Select (1) Mounting Bracket. NOTE: All (4) Brackets are universal and will fit left or right side. Attach the
Mounting Bracket to the (3) factory studs with (3) 8mm Flat Washers and (3) 8mm Nylon Lock Nuts, (Figure 4).
Snug but do not fully tighten the hardware.
4. Repeat Steps 1—3 to install the rear driver side Bracket.
5. Select the driver/left Sidebar. Carefully position the Sidebar onto the (3) Mounting Brackets. IMPORTANT: Do
not slide, (front to back or rotate), the Sidebar on the Brackets or damage to the finish on the Sidebar may
result. Attach the Sidebar to the Mounting Brackets with (4) 8mm x 25mm Hex Bolts, (4) 8mm Lock Washers and
(4) 8mm Flat Washers, (Figure 5). Do not tighten hardware.
6. Level and adjust the Sidebar and tighten all hardware.
7. Repeat Steps 1—6 to install the passenger/right Sidebar.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over the
finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
INSTALLATION INSTRUCTIONS
PART# 22660909\23060909\23261909\23461909
23562909\23662909\23962009\24062009
(12) 8mm Plastic Washers
(4) Left or Right
Mounting Brackets
Passenger/right Sidebar
illustrated for example only
8
8-1.25mm x 25mm Hex Bolts
20
8mm x 24mm OD x 2mm Washers
8
8mm Lock Washers
12
8-1.25mm Nylon Lock Nuts
Page 1 of 2 5/19/15 (DP)
SIDEBARS
2015 FORD F150 REGULAR CAB
Front