Cosco Alpha Omega Elite 65 Mode D'emploi page 29

H-2 Install Using the Lap and
Shoulder Belts
NOTE: Do not use the level to ground lines on the sides of the
shell. DO NOT use a locking clip when using this seat as a
booster seat.
1. Place Booster Seat in
Vehicle Forward-Facing
Flush Against Back Seat
Do not use any recline position
except to make the booster seat
flush against the vehicle seat
back. Vehicle seat back must
be upright.
2.
Place Child in Seat
Place the child's bottom and
back flat against the booster
seat. This will allow the vehicle
belt to be properly tightened.
Adjust the headrest so that the
midpoint of the child's ears are at
the midpoint of the headrest.
3. Buckle Lap and Shoulder
Belt
Lap belt should cross the child's
thighs (not on the stomach). The
shoulder belt should lay snugly
across the center of the child's
shoulders and across the chest
(not on the face or neck). Both belts should be under the
armrest as shown. Pull up on the shoulder belt to tighten.
55
4.
Position Shoulder Belt
To help position the shoulder
belt, you may need to secure the
shoulder belt in one of the two
shoulder belt-positioning guides
or in the adjustable shoulder belt
position guide, depending on your
model.
To adjust the adjustable shoulder
belt positioning guide, pull out on
the red end and slide up or down
the track. Release at desired
position. Make sure it locks into
place.
NOTE: Use the shoulder belt positioning guide only if necessary
to correctly position the shoulder belt on the child.
Check periodically to ensure your child has not moved out of
position and loosened the shoulder belt.
Do not use the vehicle lap
belt only when using this
seat as a booster seat.
The shoulder belt must
always be adjusted snugly
across the child's chest.
NEVER place the shoulder
belt behind the child's
back or under the child's arms.
Failure to follow these warnings can
result in serious injury or death to your
child.
56