Cosco Alpha Omega Elite 65 Mode D'emploi page 26

Installation Tip:
Loosely attach the
tether hook before
attaching the
UAS belt. Consult
vehicle's owner
manual for specific
location.
2. Connect UAS to Vehicle
UAS Anchor Bar
NOTE: The UAS connector's
red release button MUST face
away from child restraint and
the arrows on connectors
MUST face up.
Fasten one UAS connector
to the UAS anchor bar in the
vehicle seat bight. Repeat for
other side of child restraint.
3. Tighten UAS Belt
Place knee in the child restraint.
Push down firmly while pulling
up on the free end of the UAS
belt to tighten.
It may be easier to tighten
the belt through the belt path
opening as shown.
49
4.
Tighten the Tether Strap
With knee still in child restraint,
push down on the child
restraint again and pull on
free end of the tether strap to
tighten.
5.
Check UAS Belt Tightness
Grasp the child restraint
at the belt path with one
hand. Push and pull the child
restraint from side to side,
forward and back. The child
restraint should not move
more than 2.5 cm (1 in)
and the UAS belt should not
loosen.
NOTE: If it moves more than 2.5 cm (1 in.) or if the UAS
belt loosens, try reinstalling the child restraint or try another
seating location.
6.
Secure Child in Child
Restraint
To Remove UAS Belt From
Vehicle Anchor Bar
Remove child from child
restraint. Press down firmly
on child restraint and press
the red release button on
each connector and pull
the connector from the UAS
anchor bar.
50