Cosco Alpha Omega Elite 65 Mode D'emploi page 25

G-3 Prepare UAS for
Forward-Facing Use
NOTE: Pull the UAS belt out of the rear-facing belt path if
you have used this child restraint rear-facing or remove from
the storage location.
1.
Routing UAS
Insert the UAS connector without
the adjuster through the forward-
facing belt path.
2. Pull UAS Connector Across
to Opposite Side
Pull the UAS connector across
the back and out the other side
as shown. Do not twist the UAS
belt.
47
Adjuster
G-4 Install Forward-
Facing With UAS
NOTE: Review your vehicle's owner manual for UAS belt use.
Do not use the vehicle lap or lap/shoulder
belt when using the Universal Anchorage
System (UAS).
Check UAS belt before each use. Use only
if the belt can be tightened properly and
securely.
Do not fasten both UAS connectors on the
same UAS anchor bar in the vehicle.
Do not use any recline position except to
install the child restraint flush against the
vehicle seat back. Vehicle seat back must be
upright.
Failure to follow these warnings can result in
serious injury or death.
1.
Place Child Restraint in
Vehicle Forward-Facing
Flush Against Back Seat
Do not use any recline
positions except to make the
child restraint flush against the
vehicle seat back.
NOTE: Do not use the level to
ground lines on the side of the
child restraint in the forward-
facing position.
48
continued on next page.