Cosco Alpha Omega Elite 65 Mode D'emploi page 20

F-2 Prepare UAS for Rear-
Facing Use
1. Pull Pad Off Corners of Child
Restraint
Pull the seat pad off the front
corners of shell.
Unhook UAS from UAS
2.
Attachment
Press down firmly on child
restraint and press the red
release button on each
connector and pull the
connector from the UAS attachment. Remove the UAS from
the forward-facing belt path.
3. Routing UAS Belt
Insert the UAS connector with
adjuster through the rear-facing
belt path.
4. Pull UAS Connector Across to
Opposite Side
Reach under pad and pull the
1
2
UAS connector across the shell
and out the rear-facing belt path
on opposite side. UAS belt MUST
be under pad and in front of buckle strap.
Do not place belt over child's legs.
NOTE: You must use the 1st or 2nd buckle strap slots
when rear-facing.
5. Replace Pad Over Corners
Make sure the UAS belt is not
twisted.
37
NOTE: Review your vehicle's owner manual for UAS belt use.
Adjuster
F-3 Install Rear-Facing with
UAS
Do not use the vehicle lap or lap/shoulder belt
when using the Universal Anchorage System
(UAS).
Check UAS belt before each use. Use only if the
belt can be tightened properly and securely.
Secure the tether hook to the
tether attachment when used
rear-facing.
Do not fasten both UAS connectors on the
same UAS anchor bar in the vehicle.
Fully recline the child restraint and rotate the
child restraint to the correct recline angle that
matches the weight of your child. Do not use
any other recline positions rear facing. Do not
rotate the child restraint beyond the bottom or
top level to ground lines.
Failure to follow these warnings can result in
serious injury or death.
1. Place Child Restraint in
Vehicle Rear-Facing in the
Back Seat
Fully recline the child
restraint. To recline, see section
C-6.
38
continued on next page.