Operating From The Control Panel - DeLonghi EL Serie Mode D'emploi

OPERATING FROM THE CONTROL PANEL

TURNING THE APPLIANCE ON/OFF
Before plugging the appliance
check the cap on back of the unit
are correctly inserted on drain-
age hose A11.
Insert the plug in the socket.
Two dashes appear on the display
indicating that the appliance is in
stand-by.
Touch the
the appliance.
When the appliance comes on, the
last function set before it was shut off
is activated.
NOTE: After few seconds of the control
panel inactivity, its brightness will be
automatically reduced and in the next few minutes it will be
further reduced.
To turn the appliance off, touch the
Note: Never turn off the air conditioner by simply pulling the
plug. Touch the key in order to put your air conditioner in
stand-by and wait a few minutes before pulling the plug. In this
manner, the appliance can perform the operating status checks.
MODES SELECTION
To select the desired operating mode,
touch repeatedly the MODE key until
the desired function is selected.
AIR CONDITIONING MODE
This is ideal for hot and humid weather
when the room needs to be both cooled
and dehumidified.
To correctly set this mode:
• Touch repeatedly the MODE key until
the air conditioning symbol appears.
The display will show the desired tem-
perature.
• To change the temperature to be
reached, touch the
Note: The most suitable temperatures,
during the summer range from 75 to 81°F.
However, setting the temperature significantly lower than the
outdoor temperature is not recommended.
In conditioning mode, the air flow can be selected only from
the remote control.
(C1) key to turn on
key.
or key.
8
DEHUMIDIFYING MODE
This is ideal for reducing humidity in the
room (spring and autumn, damp rooms,
rainy periods, etc). For this type of use, the
appliance must be set up as for air condi-
tioner mode. That is, the air exhaust hose
(B2) must be fitted to the appliance to al-
low the humidity to be discharged outside.
To correctly set this mode:
• Touch repeatedly the MODE key until
the dehumidifying symbol appears.
• The appliance automatically chooses
the best air flow.
FAN MODE
When using this mode, the air exhaust
hose (B2) does not need to be attached to
the appliance.
To correctly set this mode:
• Touch repeatedly the MODE key until
the fan
• Select the desired air flow by touching
the increase
(C4) the key increased/decreased but-
ton.
The air flows available are:
Minimum air flow: when maximum silent
operation is desired.
Medium air flow: when the noise level needs
to be low but with a good comfort level.
Maximum air flow: for maximum performance.
HEATING MODE (On some models only)
This is ideal in spring and autumn when
outdoor temperatures are not particular-
ly severe. For this mode, the appliance
should be prepared in the same way as for
air conditioning, with the air exhaust hose
(B2) attached.
To set this mode:
• Touch repeatedly the MODE button
until the heating symbol is displayed.
• Touch increase
(C4) buttons to adjust the desired
temperature.
symbol appears.
(C3) or decrease
(C3) or decrease