Toro 88507 Manuel De L'opérateur page 6

4. When the battery is ready for storage
remove the battery from the charger.
Inserting the Battery Into
the Trimmer
1. Align the tongue of the battery pack with the
cavity in the handle housing
1. Trigger handle
2. Tongue
2. Grasp the trigger handle
3. Push the battery pack into the handle until the
latch locks into place.
Important:
The battery pack is not fully charged
when it is purchased. Before using the trimmer for
the first time, place the battery pack in the charger
and charge it until the LED display indicates
the battery is charged. Make sure to read all
safety precautions. With regular use, it will need
shorter charging time. If storing for 1 month or
longer, remove the battery and use storage mode
( Charging the Battery Pack (page
to use again, charge the battery pack until the LED
display indicates the battery is charged.
(Figure
(Figure 4).
Figure 4
3. Latch
(Figure 4).
4)). When ready
Battery Pack Preparation
3),
For Recycling
WARNING
Upon removal, cover the battery pack's
terminals with heavy-duty adhesive tape. Do
not attempt to destroy or disassemble the
battery pack or remove any of its components.
Lithium-ion batteries must be recycled or
disposed of properly at the nearest battery
recycling facility.
Troubleshooting
g021128
Using the battery when it is hot can reduce the
operating time. The battery will automatically stop
working when it is overheated to prevent damage to it.
Remove the battery from the charger and allow it to
cool before placing it back into the trimmer.
Using the battery when there is moisture on the leads
can cause the trimmer to malfunction. Allow the
battery to dry or wipe it dry before placing it back into
the trimmer.
5