Yakima HitchSki Instructions De Montage page 2

HitchSki use with RidgeBack 5 and BackRoad 4 requires the removal of the set screws under the cradles
closest to the mast, and sliding cradles to match the frame spacing of HitchSki. The outermost cradles
remain screwed in place and will support the load when both sets of ZipStrips are secured. Save these
set screws. You must reinstall the set screws on the cradle closest to the mast before using with a bike.
ASSEMBLE THE FRAME.
• The pivoting rails should go on first with cam levers facing out.
• Next, the lower rails with adjustment wheels facing out.
PIVOTING
RAIL
LOWER
RAIL
ALIGN RAILS
TO HOLES IN
FRAMES.
INSERT TWO
CAP SCREWS
INTO EACH RAIL.
RAISE ARMS AND REMOVE ZIPSTRIPS.
1033331G-2/12
THIS PRODUCT MAY NOT WORK WITH SOME TWO-BIKE CARRIERS.
warning
"YAKIMA"
CAM
CAM
LEVER
LEVER
LOAD
HITCHSKI
WITH LEVERS
TOWARD YOU.
TIGHTEN SCREWS
WITH HEX WRENCH.