Yakima StickUp Manuel D'installation page 2

attaCH tonguE to maIn aSSEmBLy.
align holes on tongue assembly
with holes on main assembly.
For 1 1/4" HItCH onLy: rEmovE tHE HItCH adaptEr.
For 2" HItCHES SkIp tHIS StEp and proCEEd to StEp 3.
FaStEn HItCH BoLt.
align holes on hitch
and tongue.
1033429E-2/21
• Remove the
set screw.
• Insert bolt through washer,
and through holes on
tongue and main assembly.
• Install second washer and
nyloc nut.
• Remove the adapter.
• Insert hitch
bolt and lock-
washer from
right to left.
• Tighten with
adjustable
wrench.
nOTE: Long bolt for 2" receivers.
Short bolt for 1 1/4" receivers.
• Install safety pin.
• Tighten with supplied
wrenches.