Fuse - Honda iGX440 Manuel De L'utilisateur

Spark Arrester Removal (low profile types)
1. Remove the three 6 mm bolts from the exhaust pipe protector
and remove the exhaust pipe protector.
2. Remove the two 6 mm bolts from the lower shroud and
remove the lower shroud.
3. To make the clearance for
6 × 16 mm bolts, 10 ×
muffler stay as shown.
4. Remove the six 6 mm bolts from the lower muffler protector
and remove the lower muffler protector.
5. Remove the three 6 mm bolts from the muffler protector and
slide the muffler protector to upside.
6. Remove the 5 × 8 mm screw from the spark arrester and
remove the spark arrester from the muffler.
6 mm BOLTS
LOWER MUFFLER
PROTECTOR
12
6 mm bolts removing, loosen the
35 mm flange bolt and slide the
EXHAUST PIPE PROTECTOR
LOWER SHROUD
6 mm BOLTS
SPARK ARRESTER
5 × 8 mm SCREW
6 mm BOLTS
Spark Arrester Cleaning & Inspection
Use a brush to remove carbon
1.
deposits from the spark arrester
screen. Be careful not to damage
the screen. Replace the spark
arrester if it has breaks or holes.
2. Install the spark arrester to the
muffler.
3. STANDARD TYPES
Install the muffler protector and air cleaner in the reverse order
of disassembly.
LOW PROFILE TYPES
Install the exhaust pipe protector, lower shroud, lower muffler
protector and muffler in the reverse order of disassembly.
FUSE (applicable types)
If the fuse is blown, the battery cannot be charged.
Fuse change
1. Remove the fuse cover and
pull the fuse out.
2. Replace the fuse with a fuse
of the same type and rating.
Never use a fuse with different
rating from that specified.
Serious damage to the electrical
system or fire may result.
3. Install the fuse cover.
ENGLISH
10 × 35 mm
FLANGE BOLT
MUFFLER STAY
6 × 16 mm
BOLT WASHER
SCREEN
FUSE COVER

FUSE

(30 A)
FUSE
(3 A)