Mapping Your Home - Bissell ReadyClean A3 Mode D'emploi

MAPPING YOUR HOME

MAPPING YOUR HOME
First Use: Creating the map First Use: Creating the map
After the robot is fully charged, short press
" " on the docking station. The robot
will leave the docking station and begin
exploring your home and building a map of
your floor plan.
Note: The robot is NOT cleaning while building
the map. The cleaning pad will be lifted up as
it explores your home.
EN
Tips while mapping Tips while mapping
Do not follow or stand in the way of the robot as
it is mapping. This can cause missing spots or
errors in your floor plan map.
Open doors and remove obstacles to ensure
the most accurate and complete map.
The robot will continue to optimize and adjust
the map each time it goes out to clean.
Download the ReadyClean APP by BISSELL to see
your completed map and interact with your floor
plan (mark areas as off limits, set pad changing
by room or area cleaned, etc.)
Do not move the Docking Station Do not move the Docking Station
Do not move the docking station unless
necessary. Moving the docking station will
require you to remap your floor plan.
Remap as the following steps
1) Long press " + "for 8 seconds: Factory
reset the robot.
2) Follow the step"First Use: Creating the
map"to remap
17