Connecting Accessories - Mectron MICROPIEZO Mode D'emploi Et D'entretien

MICROPIEZO
4.3 Connecting Accessories
The device is provided with a "wall"
type external power supply unit and
with interchangeable plug. Identify the
appropriate type of plug and insert it into
the power supply unit in such a way that
the guides present on both parties are
aligned. Slide the plug until you hear a
"click".
CAUTION: If correctly assembled,
the plug must not move or disconnect. If
the plug is not properly secured, remove
it and re-insert it. To remove the plug,
press the hold button and slide the plug
outwards.
CAUTION: Use only the power
supply unit supplied with the device or
an original part MECTRON.
In order to prevent
deformation of the water circuit or the
manifestation of wear due to non-use,
the system is supplied with the peristaltic
pump not installed.
To install the peristaltic pump:
1. Remove the cover located on the
back of the device;
2. Insert the peristaltic pump and
make sure that the pin of the
impeller and the clip (upper and
lower) coincide with the respective
seats.
3. Press up to the complete insertion
of the clips.
4. Insert the water conduits in the
relative sleeves for the whole
length of the latter.
5. Close the cover.
14
1
2
permanent