DeWalt DWX726 Guide D'utilisation page 7

If your saw does not readily fit the mounting rails:
iMPORTAnT: The miter saw MUST be positioned so the tool is bolted squarely to the mounting rails. If this is not possible,
please call 1–800–4-D WALT (1–800–433–9258) for technical assistance.
e

WARNING: STABILITY HAZARD. If the tool's mounting holes do not line up with the slots in the mounting rails, mount
the miter saw to a piece of 3/4 " (19 mm) plywood (See Figure L for dimensions). The plywood must be a minimum of 4 "
(101.6 mm) wider than the tool base being mounted and a minimum depth of 17 " (431.8 mm). Plywood must be at least
as deep as the tool base being mounted. Drill 3/8 " (9.5 mm) holes near both ends of the plywood to align with the slots
in the mounting rails as described in Attaching the Tool. Other hardware (not supplied) may be necessary under these
circumstances.

WARNING: STABILITY HAZARD. All purchased hardware must be a minimum of Grade 2. Hardware should be
1–1/4 " (31.8 mm) longer than the thickness of the tool base you are assembling.
NOTICE: To prevent binding and/or inaccuracy, ensure the plywood is not warped or uneven. If binding and/or
inaccuracy occurs, replace the plywood with a non-warped, even piece of plywood.
Fig. L
minimum of
17" (431.8 mm)
Must be at
least as deep as
the saw being
mounting
1" (25.5 mm)
TO RAISE AND LOWER THE STAND (FIG. A, M, O)

WARNING: PINCH AND IMPACT HAZARD. The spring loaded mechanism is under tension and can open unexpectedly,
with high force.
1. Turn the stand right side up on the floor.
iMPORTAnT: Stand must be right side up when cutting white cable ties
Fig. M
2. While holding down on the top of the stand frame, use wire cutting pliers to cut the white cable ties.
iMPORTAnT: DO nOT cut the black cable ties securing the cables that open the stand.
3. Place one foot on the bottom of the leg extension
with one hand, push the red activating lever
mechanism.
4. Lift the handle with both hands.
8
The stand has three positions: closed, fully extended
and intermediate
To Reach the intermediate Position:
Lift up on the handle and slowly raise the stand. The stand will stop at the
intermediate position. Release the lever.
nOTE: When in the intermediate position, the stand will lower slightly when a
tool is placed on it. The intermediate position does not lock against upward motion. The stand relies on the weight of the
tool to remain in the intermediate position.
width of Saw + 4" (101.6 mm)
1" (25.5 mm)
16"
(406.4 mm)
both
sides
4
12 to disengage the latching
1" (25.5 mm)
mount miter saw in
shaded area
.
34
. Hold the handle down
3/8"
(9.5 mm)
diameter
holes, all 4
corners
2" (50.8 mm)
minimum both
sides
1" (25.5 mm)
Fig. N
34
Fig. O
12 8
English
4
5