Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
I
EN
36
Programming
Overview
The following settings can be made in programming mode:
· assigning and deleting door codes,
· allocating rights,
· changing the release interval,
· change code length,
· changing the master code,
· activating and deactivating the permanent lock function,
· setting special functions (hotel and carrier function).
Master code
An individual master code (access and programming code) is already set in the
factory (page 102). The master code can be changed with a programming
function ("Table of function codes", page 40).
Entering and exiting the programming mode
Note!
Exit programming mode automatically: The programming mode is exited auto-
matically after 30 seconds with no inputs.
Switch on programming mode
99
Enter master code
Programming mode: active
Signal tone: with each push of a
button: (Fig. 1 page 37)
Switch off or cancel program-
ming mode
X X X
or
Wait 30 s
LED: 2x green
Programming mode: inactive
Signal tone: none when a button is
pushed
Normal operating mode: active
Programming
Publicité
Table des Matières
