Step 7: Backguard Installation - Thermador PRO-GRAND PG30 Instructions D'installation

The backguard must be attached before sliding the
range into the final installed position. A Low Back or
Pot and Pan Shelf must be installed when there is less
than a 12" clearance between combustibles and the
back of the range above the cooking surface. (See
Fig. 2A and 2B on Page 5).
An Island Trim is available for covering the backguard
mounting flanges for island installations, where there
is a minimum of 12" of horizontal clearance between
combustibles and the back of the range. (See Fig. 2B
on Page 5).
The backguard is inserted, as shown in Fig. 8, into the
guide channels on the back of the range. Secure the
backguard with the (4) sheet metal screws provided.
Chart C: Backguard Kit Model Numbers
Model Width 9" Std. Low Back
30" Included
36" N/A
48" N/A

Step 7: Backguard Installation

12" Low Back
N/A
LB36R
LB48R
14
FIG. 8
Front of Unit
22" Pot and Pan Shelf
HS30R
HS36R
HS48R
Backguard
Installed
3-3/4" Island Trim
IT30R
IT36R
IT48R