SKYLOTEC PEANUT Instructions D'utilisation page 12

should move freely and not be subjected to cross-loading or loading
over an edge.
Using two PEANUT devices (2x I-Version, each with a shock
absorber) at the same time is strictly prohibited (table on page 8,
line 9). Noncompliance can result in death.
The Y-Version is to be used in this instance. When using the
Y-Version, the free end is not to be attached to a gear loop of the
safety harness. (Risk of reduced deployment, table on page 8,
line 8)
2.1) Labels
3.) Use on mobile elevating work platforms
To minimise the risk of being thrown out, always set the length
between the work platform anchor point and the attachment point
of the safety harness as short as possible!
3.1) All of the PEANUT range with a length of 1.80m is suitable for
use on elevating work platforms (EWP). Only anchor points
mounted a minimum of 35cm beneath the handrail can be used.
Risk-free usage is no longer guaranteed when using a higher
anchor point.
3.2) The anchor point (AP) and the whole of the platform must be
able to absorb a dynamic jolt even in the most unfavourable of
circumstances. The following drop tests were carried out for
certification and the respective impact forces established:
100kg:
Direct fall = max. 3kN impact force
Sideways fall = max. 6kN impact force
135kg:
Direct fall = max. 6kN impact force
Sideways fall = max. 6kN impact force
Clarify the load-bearing capacity of the platform before use.
If the AP is higher, there is a risk of complete failure and it tipping
over! The device must only be used with mobile elevating work
platforms which are equipped with an anchor point(s) as part of the
work platform's fall arrest systems. Only use anchor points with the
12 12
MAT-BA-0154-01_20210503.indd 12 MAT-BA-0154-01_20210503.indd 12
1. Manufacturer + address
2. Length
3. Read instructions
4. Relevant standards + year of issue
5. Product name
6. CE marking of the supervisory body
7. Date of the next inspection
8. QR code
9. Month and year of manufacture
10. In-house barcode
11. Article number
12. Serial number
13. Max. nominal load
14. User Identification
03.05.2021 14:16:02 03.05.2021 14:16:02