Torin BIG RED T820050RJ Mode D'emploi page 6

ASSEMBLY INSTRUCTIONS
In order to prevent removal of the post from the base use a hammer and flat end punch to hammer the jack's tab in toward to post
but not touching the post. Same stands are equipped with a bolt instead of the tab. In this case the bolt can be threaded in toward
the post until the bolt bottoms out.
1. Install ratchet bar into frame (Fig.1) with ratchet portion of bar aligned with locking pawl (stopper).
2. Move the ratchet bar to its lowest position by raising the locking handle, thereby releasing the stopper, and guiding the bar
downward (Fig. 2).
3. Bend metal tab in (Fig. 3) using a hammer and punch. This will help prevent inadvertent separation of the ratchet bar from base
frame.
Fig.1
OPERATING INSTRUCTIONS
• If the operator is not fluent in English, the product and safety instructions shall be read to and discussed with the operator in the
operator's native language by the purchaser/owner or his designee, making sure that the operator comprehends their contents.
• Visual inspection shall be performed before each use of the stand by checking abnormal condition, such as cracked welds, leaks
and damaged, loose, or missing parts if stand is believed to have been subjected to abnormal load or shock inspection shall be
made by authorized repair facility.
• Equipment that appears damage or worn or operates abnormally shall be removed from service.
1. Use on hard level surface with less than 3 degrees of slope.
2. Raise Vehicle with suitable jack.
3. Adjust height by pulling up on ratchet bar.
4. The weight of the locking handle should secure the ratchet bar in desired position. To confirm this, simply push down on the
locking handle. Check to ensure ratchet is secure before loading.
5. Carefully position jack stands so that load is centered on stand's saddle.
6. Slowly lower the vehicle onto the stands.
7. Check to ensure vehicle is secure before working on, around or under. When used to support vehicle, use wheel chocks on all
unlifted wheels in both directions to prevent inadvertent movement.
8. DO NOT jack or dolley while jack stands are supporting the vehicle.
TO LOWER LOAD
1. Ensure that all tools, equipment and personnel are clear before lowering load.
2. With suitable jack, raise vehicle clear of stands.
3. Carefully release stopper and allow ratchet to glide down to lowest position.
4. Carefully remove stands, then carefully lower vehicle with lifting device.
Fig.2
6
Fig.3
Metal tab