Important - NAD C315BEE Manuel D'installation

warning
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE. THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL,
WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE
PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S
ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK
OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS
INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT
OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE
caution
Changes or modifications to this equipment not expressly approved by NAD
Electronics for compliance could void the user's authority to operate this equipment.
caution regarding placement
To maintain proper ventilation, be sure to leave a space around the unit (from the
largest outer dimensions including projections) equal to, or greater than, shown
below.
Left and Right Panels : 10 cm
Rear Panel : 10 cm
Top Panel : 50 cm
important information for uk cuStomerS
DO NOT cut off the mains plug from this equipment. If the plug
fitted is not suitable for the power points in your home or the cable
is too short to reach a power point, then obtain an appropriate safety
approved extension lead or consult your dealer. If, nonetheless, the mains plug is cut
off, REMOVE THE FUSE and dispose of the PLUG immediately, to avoid possible shock
hazard by inadvertent connection to the mains supply. If this product is not provided
with a mains plug, or one has to be fitted, then follow the instructions given below:

important

DO NOT make any connection to the larger terminal which is marked with the letter 'E'
or by the safety earth symbol or coloured GREEN or GREEN AND YELLOW.
The wires in the mains lead on this product are coloured in accordance with the
following code:
BLUE - NEUTRAL
BROWN - LIVE
As these colours may not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
The BLUE wire must be connected to the terminal marked with the letter 'N' or
coloured BLACK.
The BROWN wire must be connected to the terminal marked with the letter 'L' or
coloured RED
When replacing the fuse, only a correctly rated and approved type should be used,
and be sure to re-fit the fuse cover.
if in doubt conSult a competent electrician
This product is manufactured to comply with the radio interference requirements of
EEC DIRECTIVE 89/68/EEC and 2006/95/EEC.
IMPORTANT SAFETY INSTRUCTIONS
noteS on environmental protection
At the end of its useful life, this product must not be disposed of with
regular household waste but must be returned to a collection point for
the recycling of electrical and electronic equipment. The symbol on the
product, user's manual and packaging, point this out.
The materials can be reused in accordance with their markings. Through re-use,
recycling of raw materials, or other forms of recycling of old products, you are making
an important contribution to the protection of our environment.
Your local administrative office can advise you of the responsible waste disposal point.
Model No. :________________________
Serial No. :_________________