Error Displays/Messages - Sony CDX-M800 Mode D'emploi

Masquer les pouces Voir aussi pour CDX-M800:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Automatic tuning is not possible.
• The local seek mode is set to "on."
t Set the local seek mode to "off" (page
18).
• The broadcast signal is too weak.
t Perform manual tuning.
The "ST" indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set to the monaural reception mode (page
18).
A program broadcast in stereo is heard in
monaural.
• The unit is in monaural reception mode.
t Cancel monaural reception mode (page
18).
Interference occurs during FM reception.
The wide mode is selected.
t Set the IF mode to "IF Auto" (page 18).

Error displays/Messages

Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about 5
seconds, and an alarm sound will be heard.
Blank*
1
No tracks have been recorded on an MD*
t Play an MD with recorded tracks on it.
Error*
1
• A CD is dirty or inserted upside down*
t Clean or insert the CD correctly.
• A CD/MD cannot play because of some
2
problem*
.
t Insert another CD/MD.
Failure*
3
The connection of speakers/amplifiers is
incorrect.
t See the installation guide manual of this
model to check the connection.
FAILURE*
3
When the XM tuner is connected, storing an
XM radio channel into a preset failed.
t Be sure to receive the channel that you
want to store, then try it again.
High Temp
The ambient temperature is more than 50°C
(122°F).
t Wait until the temperature goes down
below 50°C (122°F).
NO Disc*
1
No disc is inserted in the CD/MD unit.
t Insert discs in the CD/MD unit.
NO Magazine
The disc magazine is not inserted in the CD/
MD unit.
t Insert the magazine in the CD/MD unit.
NO Music*
2
A CD which is not a music file is inserted in
the MP3 playable CD unit.
t Insert a music CD in the MP3 playable CD
unit.
Not Ready
The lid of the MD unit is open or the MDs are
not inserted properly.
t Close the lid or insert the MDs properly.
Offset
There may be an internal malfunction.
t Check the connection. If the error
indication remains on in the display,
consult your nearest Sony dealer.
continue to next page t
2
.
2
.
25

Publicité

Table des Matières
loading

Table des Matières