Dyna-Glo DGX440SGN Mode D'emploi page 19

Operation Instructions
Lighting The Grill and/or Griddle – Before first use:
Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important
to clean your grill with heat. To do this, operate the grill for approximately 15 minutes with the lid closed
and the control knobs in the highest position. This will clean the internal parts by burning off any residue
and odor from the manufacturing process.
Before you use your griddle for the first time, please read the next page for instructions on how to
properly season the griddle surface.
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF
the natural gas shut-off valve and then TURN OFF the control knob.
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO PREVENT
FIRE, DAMAGE AND/OR INJURY.
Do not lean over grill when lighting. Read instructions before lighting.
1. Check that the control knobs are in the O OFF position.
2. Open natural gas supply at shut-off valve.
3. Open lid during lighting.
4. Depress and turn control knob counterclockwise
position, to the high position for the burner. You may need to repeat several times to ignite the
burner. If ignition does not occur in 5 seconds, turn the control knobs to
minutes, and repeat the lighting procedure.
If the burner still does not light, check that the natural gas shut-off valve is open and follow the match
lighting instructions on page 21.
CAUTION
WARNING
O
from OFF position, past the
19
ignite
O
OFF position, wait 5