Adjustable Parameters - IFM Electronic Efector 600 TN7430 Notice Utilisateurs

3. Adjustable parameters

(menu sructure: see fold out page)
Switch-on point: Upper limit value at which the output changes
its switching status.
°C
°F
Switch-off point: Lower limit value at which the output chan-
ges its switching status.
°C
°F
rPx is always lower than SPx. The unit only accepts values which
are lower than SPx.
Changing the switch-on point also changes the switch-off point
(the hysteresis remains constant).
If the hysteresis is higher than the new switch point, it is
automatically reduced (rPx is set to the minimum setting value).
Configuration of the switching outputs
4 switching functions can be set:
Hno = hysteresis / normally open
Hnc = hysteresis / normally closed
Fno = window function / normally open
Fnc = window function / normally closed
Setting of the display
4 options can be selected:
°C = display in °Celsius
°F = display in °Fahrenheit
r°C = display in °Celsius (inverted)
r°F = display in °Fahrenheit (inverted)
Calibration offset
The internal measured value (operating value of the sensor) is
offset against the real measured value.
°C
°F
setting range
-39.5 ... +125
-39 ... +257
setting range
-40 ... +124.5
-40 ... +256
setting range
-9.9 ... +9.9
-17.5 ... +17.5
in steps of
0.5
1
in steps of
0.5
1
in steps of
0.1
0.5
15