Glass Cover Replacement; Leak Check - Furrion FGHWCLDA-BL Manuel D'instructions

Connect a positive 12V power supply wire to the cooktop
black 12V light wire and a negative 12V power supply wire to
the cooktop white 12V light wire. (Fig. 8)
NOTE: Ensure to connect the wires with the correct polarity.
Black is "+" and White is "-".
Fig. 8
+
12V DC
Switch
-

Glass Cover Replacement

1. Align the top glass cover assembly with the slots on the
cooktop and place it into the cooktop. (Fig. 9)
Fig. 9
Ignition
Right Center
Left
Knob
Burner Burner
Burner
LED
Knob LED Knob LED
Knob LED
2. Press the backside of the top glass cover and you will
hear a click noise. The top glass cover is now locked into
place. (Fig. 10 and Fig. 11)
Fig. 10
Fig. 11

Leak Check

WARNING
FIRE OR EXPLOSION
Extinguish all open flames.
NEVER leak test when smoking. Never use a flame.
Do not use the appliance until connection has been leak
tested and does not leak.
Pressure/Leak test using 11-13.8 WC pressure.
WARNING
Gas leaks may occur in your system and result in
a dangerous situation. Always perform a leak test
for possible leaks according to the manufacturer's
instructions after installation and before any operation.
Gas leaks may not be detected by smell alone. Gas
suppliers recommend you purchase and install a UL
approved gas detector.
1. Make sure all control knobs are in the OFF position.
2. Apply a gas leak detection liquid to the connections.
gas leaks will be indicated by bubbles.
3. If a gas leak is detected, tighten the loose joint, or replace
the faulty part with a replacement part recommended by
Furrion authorized retailer.
REV: 10.15.2022 CCD-0005608
Any
9