SWITCH POSITIONS
Left: Flow/Heat, Middle: Flow, Right: Motor
HOW TO OPERATE
•
First, find a stable surface near an electrical outlet before starting. Unit must be level
to operate properly and to create the desired flowing effect. Make sure your cord is
away from any water source. If needed, it is acceptable to use an extension cord.
•
Pull the lever all the way forward to turn the switch on the right to start the heater
on the 4-TIER CHOCOLATE FONDUE FOUNTAIN. It will be labeled "Flow Heat." Let
the unit warm up for at least 3 – 5 minutes before adding melted chocolate.
•
While the machine is warming up, get a microwaveable bowl. Fill bowl with two pounds
of chocolate chips (32 ounces) and ¾ of a cup of oil. You may need to add more oil to
ensure proper flow. If you are using Belgian Chocolate, you do not need to add oil.
•
Place in microwave for 2½ minutes. When done, stir chocolate. If necessary, continue
to warm chocolate in microwave until melting is complete (another 2 to 2½ minutes).
DO NOT heat chocolate over 110
•
Never add cool or cold liquids to the melted chocolate
in the fountain as this will stop the flow.
•
Chocolate needs to be completely melted and of thin consistency to allow
proper flow. Use a large spoon to test the consistency of the chocolate. If the
chocolate drips too thickly from the spoon, add more oil to the mixture.
•
Once the chocolate is completely melted and of proper consistency, carefully
pour the melted chocolate into the Bowl at the base of the Tower. The melted
chocolate should be drawn under the Tower and carried up the Tower by the
Auger. Chocolate should then begin to flow from the top of the Tower and
cascade evenly down each tier. Keep the lever on the "Flow/Heat" position.
When heating is not needed, push the lever to the middle "Flow" position.
•
The 4-TIER CHOCOLATE FONDUE FOUNTAIN must be level to ensure
proper sheeting of the chocolate. Be careful not to drop pieces of
food into the Bowl which clogs the flow of chocolate.
F as warping of the towers may occur.
o
6