Bergstrom LITE Mode D'emploi page 20

LITE
EN
Symptom
• When the unit starts up or runs, the
display shows EC (communications
cable failure).
automatically,
continuing to show
anomaly is put right. To remove EC
from the display, press the On/Off
key once on the control panel or
remote control.
• The unit gives out a beeping sound.
• E9 will appear when the unit has a
slant of over 45º (tilting the cabin).
• Water is entering the cabin or is
filtering in from outside.
The unit goes off
with the display
EC until the
• Poor connection in terminals or cables of
the communication cable.
• Communication
connected or disconnected.
• Belt poorly connected in the keypad or
inverted.
• Unit slant 45º or over.
• Run-off channel blocked.
• Run-off seal blocked.
• EPDM seal poorly attached or defective.
• The cable outputs in the evaporator cover
are not sealed properly.
20
Cause
cable clamps poorly