Pocket Cutting; Adjustments - RIDGID R3204 Manuel D'utilisation

OPERATION

POCKET CUTTING

See Figure 19, page 17.
WARNING:
Always adjust bevel setting to zero before making
a pocket cut. Attempting a pocket cut at any other
setting can result in loss of control of the saw
possibly causing serious injury.
 Adjust the bevel setting to 0° and lock the bevel adjust-
ment lever.
 Set the blade to the correct blade depth setting.
 Swing the lower blade guard up using the lower blade
guard handle.
NOTE: Always raise the lower blade guard with the handle
to avoid serious injury.
 Hold the lower blade guard by the handle while keeping
your hand on the front handle as shown.
WARNING:
Never extend your fingers while holding the lower
blade guard handle. Extending your fingers may
result in contact with the blade, causing serious
injury.
 Rest the front of the base flat against the workpiece with
the rear of the handle raised so the blade does not touch
the workpiece.

ADJUSTMENTS

WARNING:
Before performing any adjustment, make sure the
tool is unplugged from the power supply and the
switch is in the OFF ( O ) position. Failure to heed
this warning could result in serious personal injury.
POSITIVE 0 ° BEVEL STOP
See Figure 20, page 17.
The saw has a positive 0
°
adjusted to assure 0 angle of the saw blade when making
°
0 cuts. However, misalignment can occur during shipping.
°
bevel stop that has been factory
WARNING:
Always check to insure that your fingers are clear
of the blade before depressing the switch trigger.
Contact with the blade will cause serious injury.
 Start the saw and let the blade reach full speed. Always
let the blade reach full speed then slowly lower blade into
the workpiece until base is flat against workpiece.
 Guide the saw into the workpiece and make the cut.
WARNING:
Always cut in a forward direction when pocket
cutting. Cutting in the reverse direction could
cause the saw to climb up on the workpiece and
back toward you.
 Release the trigger and allow the blade to come to a
complete stop.
 Lift the saw from the workpiece.
 Clear corners out with a hand saw or sabre saw.
WARNING:
Never tie the lower blade guard in a raised position.
Leaving the blade exposed could lead to serious
injury.
°
To check 0 bevel stop:
 Unplug the saw.
 Place saw in an upside down position on a workbench.
 Move the lower blade guard out of the way so that the
saw blade is exposed.
 Check the squareness of the saw blade to the base of
the saw using a combination square.
12 - English