Hopper Dumping - Nilfisk SW4000 Instructions D'utilisation

HOPPER DUMPING

WARNING!
The hopper (11) must be emptied on level grounds only.
Do not lift the hopper when the machine is on a slope.
WARNING!
When lifting and dumping the hopper (11), make sure that there are no people around the machine, especially
near the hopper.
NOTE
When the hopper (11) is lifted, the vacuum system turns off automatically and the machine maximum speed is reduced
for safety reasons.
To empty the hopper, move the machine close to the dustbin and proceed as follows.
1. Lift the side and main brooms.
2. Press the enabling switch (66) while pressing the hopper lifting switch (81) to lift the hopper (A, Fig. 1) up to the desired
position.
3. Drive the machine to the disposal area and engage the parking brake.
4. Dump the hopper (B) with the lever (C) to discharge all dust and debris collected (D).
NOTE
If necessary, manually engage the hopper in position (A) with the returning handle (E) when the hoisting system is lifted
and the hopper is disengaged (B).
CAUTION!
The hopper (A) can be dumped only when lifted at a minimum height of 35 cm approximately.
The maximum dumping height is approx. 150 cm.
5. Lower the hopper by pressing both the enabling switch (66) and the switch (81).
NOTE
To ensure that the hopper (11) is fully retracted, check that the warning light (76) is off.
6. The machine is ready to start sweeping again.
03/2013
INSTRUCTIONS FOR USE
A
max
100 Kg
(220 lb)
Figure 1
1464809000 - SW4000, FLOORTEC R 870
ENGLISH
C E
D
P100592
B
17