Lock Mode - Monacor International JTS US-903DCPRO/5 Mode D'emploi

Note: It is not possible to set both receiving units
to the same channel The channel selected for one
receiving unit will be automatically skipped during
channel adjustment for the other receiving unit
5) To save the adjustments for the reception group
and the transmission channel, press the key
SET The display will briefly indicate
adjusting mode will be exited, and the unit will
go to normal operation

6.1.1 Lock mode

(locking the channel selecting keys)
To prevent accidental change of the transmission
channels selected, it is possible to activate the
lock mode With the lock mode activated, it is
not possible any more to call up the reception
group mode / channel adjusting mode for both
receiving units
1) To activate the lock mode, keep the key SET (9)
in one of the operating panels pressed for 2 s
until the display briefly indicates
the reception group adjusted will flash Press
the key SET two more times until
flash in the display Press the key  (7) so that
will flash in the display now Then press
the key SET
the unit will go to normal operation
2) To deactivate the lock mode, keep the key SET
in one of the operating panels pressed for 2 s
until flashes in the display With the key
 (8), switch to
key SET
allows operation of the keys without limitation
Note: The lock mode will not be deactivated by switching
off the receiver After switching on, the channel selection
will continue to be locked
14
is briefly displayed before
and confirm with the
will briefly be displayed, the unit
6.2 Recharging the
rechargeable batteries
The integrated quick charging unit allows charging
of two pairs of NiCd or NiMH rechargeable batter-
ies of size AA Four NiMH rechargeable batteries
(1300 mAh) are supplied with the receiver
, the
CAUTION! Use the charging unit only to re-
charge rechargeable NiCd or NiMH batteries If
attempts are made to recharge non-rechargeable
batteries, they can leak or explode!
a
Then
will
Fig. 5 Open compartment of the
rechargeable batteries
1) To open the compartment (5) for the recharge-
able batteries, press the symbol
partment disengages and can be pulled out up
to the stop
2) Either insert one or two pairs of rechargeable
batteries (a, b) into the compartment, with the
positive and negative poles as shown in fig 5
The correct polarity is also printed on the front
of the compartment Insert the rechargeable
batteries so that the respective pole of the bat-
b
The com-