BGS technic 8911 Mode D'emploi page 4

USE
1. Locate and mark the point where the air escapes.
2. If there is a foreign body (screw, nail, etc.) in the tyre, remove it.
3. Widen the puncture point with the stitch awl (1).
4. Insert the tyre repair plug (4) halfway into the tyre plug installing tool (3).
5. Put some assembly paste on the puncture point and the centrally of the repair plug.
6. Place the tip of the tyre plug installing tool (3) on the puncture point and press the tyre repair
plug (4) into the puncture point until the ends of the tyre repair plug protrudes approx. 10 to 20
mm from the tyre surface.
7. Now pull the tyre plug installing tool (3) straight up out of the tyre, without turning it.
8. Use the safety knife (5) to cut off the tyre plug ends flush with the tyre tread.
Step 1
Step 4
Step 7
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Step 2
Step 5
Step 8
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Step 3
Step 6
Step 9
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed