Metabo HPT SV 1813DA Manuel D'instructions page 14

English
CAUTION
If too much dust accumulates in the dust bag,
the dust collection power will be reduced.
Dispose of dust as soon as possible.
5. Adjustment of speed
The sander is equipped with an electric control circuit
that enables speed control. To adjust the speed, turn
the dial shown in Fig. 9. When the dial is set to "1", the
sander operates at the minimum speed (7,000 /min).
Table 5 By adjusting the dial, match the speed to the material and type of work.
Material
Paintwork:
Sanding
Repairs
(scratches, rust spots)
Stripping
Wood:
Softwood
Hardwood
Veneers
Metals:
Aluminium
Steel
Stainless steel
NOTE
Please use this table as a standard.
6. Confi rm the switch is in OFF position
CAUTION
Before installing or removing the battery, turn
the switch to the OFF position.
If the battery is inserted with the switch in the ON
position, the motor will operate unexpectedly.
7. Check battery insertion
CAUTION
Until the battery locks in place with a little click,
if not, it may accidentally fall out of the tool
causing injury to you or someone around you.
14
When the dial set to "6", the sander operates at the
maximum speed (11,000 /min). Adjust the speed
according to the material to be cut and working
effi ciency.
Grain
Rough grinding
180
120
40
60–80
60
240
80
60
120
OPERATION
WARNING
● Be sure to turn off the switch, then remove the
battery from the tool in the following situations:
• When stopping or ending work
• When attaching or removing accessories or
• When maintaining, inspecting, or storing the
Fig. 9
Fine grinding
400
240
80
240
180
320
240
240
240
optional parts
tool
Dial
Dial scale
3–6
2–4
2–4
3–6
3–5
2–4
2–4
3–6
3–6