D-Link DAP-1820 Guide D'installation Rapide page 10

What if I forgot my DAP-1820 password?
1. If you forgot your password or want to reset the DAP-1820
back to the factory default settings, press and hold the
reset button on the bottom of the extender using a paper
clip and release after a minimum of 10 seconds. The Status
light will turn red.
Note: This process will erase all your settings.
2. You may repeat the WPS process on page 4. Follow the
steps under Connect to Your Router Using WPS.
What if WPS setup is not working?
WPS may not be enabled on all Routers or Modems. If the
Status LED on your Range Extender does not turn solid
green after running WPS setup, try again. If it still does not
turn solid green, see Configure the DAP-1820 Using D-Link
Wi-Fi Setup, on page 6.
10
Reset
Button
DAP-1820 Install Guide