Remote Control - Kimex 161-4300 Manuel D'utilisation

REMOTE CONTROL

Battery installation
• Remove the battery cover on the back of the remote control and insert
two AAA (1.5V) batteries. Make sure that the polarity matches the +
and - marks on the battery compartment of the remote control.
•
Do not use different types of batteries. Never mix new and old
batteries. Always replace batteries in pairs.
•
Do not burn, charge or disassemble batteries.
Never dispose of used batteries with household waste but in the
recycling bins provided for this purpose, e.g. in your supermarkets or in
accordance with local environmental regulations.
Precautions for using the remote control
• Aim at the infrared receiver located below the right corner of the
screen. Do not place any objects between the remote control and the
receiver to avoid interference and to ensure normal operation.
• Keep the remote control away from strong vibrations. Do not place the
remote control under direct sunlight or on a radiator, as this may
deform and damage it.
• The remote control signal may not work if the infrared receiver is
exposed to sunlight or strong lighting. In this case, adjust the angle of
the lighting on the device or move closer to the receiver.
• The maximum operating distance of the remote control is 5 m, which
can be shortened if the battery charge is insufficient, in which case
replace the batteries with new ones. If the remote control is not used
for a long period of time, remove the batteries to prevent corrosion
that could damage the remote control.
Page 27 de 28